Welcome to our forum.
i just tried running it without the controls hooked up same result as before motor cycles on and off
120 volt to pump, when it switches from high to low it is switching power to the high side, shutting off the low speed power. i have noticed it seems to not be pushing as much water as well.
with the motor turning on and off , could this be a sign of the motor going bad? I'm not sure if I'm missing something obvious...
The power going to the motor seems to be steady, when it starts turning on and off I can hear the relay switching as well, I let it run for a while and got an error which indicated a temp difference , (caused by low flow) the motor doesn’t seem to be able to go into high speed mode when connected to the panel .
all fixed! the motor was fine... it didn't have a label so i had assumed it was 120 when i talked to the motor repair guy, i was wrong, simple change of wiring in the control panel and it runs great! thanks again everyone , very rookie mistake!!