Hot Tub Forum
Original => Hot Tub Forum => Topic started by: sledjunkie on July 06, 2006, 12:18:09 pm
-
I did some math and for a 7.5' x 7.5', 4" thick pad it's going to take about 32 80lb bags of quikrete.
Is this overkill?
Could I get away with say a 2" thick pad?
-
4" reinforced pad is what I've always said.
-
4" reinforced pad is what I've always said.
And what my dealer and several others have said. Many cement people who pour pads use that as a default.
-
If a sidewalk that only supports foot traffic are layed 4" thick, you'd better go with 4" for a possibly multi-ton hot tub.
IMHO
-
4" reinforced pad is what I've always said.
We had a 4" pad that was not reinforced and never had a problem.
-
4 inch reinforced, thicker if it is not on level ground.
-
4 inch reinforced, thicker if it is not on level ground.
-
My pad is 4"-5" and 18'x25' and so far so good. There were cracks that showed up a few weeks afterwards from settling, but that was never an issue since we had planned to cover the concrete with 1'x1' slate anyway. I have been doing the slate work this week and hope to be finished by sunday.
-
4" minimum. Depending on where you live there may be different PSI requirements. Mine was 3500 PSI. I would get a truck to deliver the concrete, not mixed in bags. It will be worth your back and time to get it delivered.
You may even want to prepare the surface with a compacted gravel base. 2 things concrete will do.. cure and crack :)
Remember your tub with water and people could weigh 6,000 pounds. That is the weight of a Toyota Sequioa.
-
Here is a photo of my slate project so far. I ended up with 320 1-foot square sections of slate installed on the concrete pad, and what a job that was. Now that I'm getting near the finished product it is starting to look ok. The tiles are still a bit dirty from the grout, but its not too bad. Tonight I hope to finish the cleaning and will add the sealer. It does look better then the plain ol' concrete.
(http://i39.photobucket.com/albums/e165/hyak/spa_tile.jpg)
-
thanks for the replies everyone. I will be doing a 5" deep 7.6' x 7.6' pad. I will also be using wire mesh.
-
How long should you let the concrete cure, before placing the spa? I've heard conflicting opinions from friends, one said 5-7 days depending on the weather. Another said to let it cure a month...?
-
Jack.....the slate looks awesome!
Ten times better than "plain concrete".
Please keep posting pics of your project.
Very nice!
ps: My slab is 4.5 inches thick....
I would think 2 inch could cause
problems down the road. Do it
right the first time!
-
I have a 20x20 slab that's 4.5" thick and its reinforced with rebar and mesh, which if your putting a tub on is a must. Even with that, I still have two cracks that run the length and width of the slab. I would suggest cutting across the middle in both directions when its finished. Another suggestion is to stamp it in a flagstone or other patterns if you want to dress it up, then either stain it or use colored concrete. It might cost a little, but the end result is well worth it.