Hot Tub Forum

Original => Hot Tub Forum => Topic started by: Rodder98 on May 27, 2015, 08:04:12 pm

Title: New to Hot tubs, need some help getting it started
Post by: Rodder98 on May 27, 2015, 08:04:12 pm

I received a hot tub for free. Finally  got around to installing the electrical and putting it in place. I connected the power, flipped the breaker, and I heard 2 clicks, but nothing happened. No light, no panel messages, no pumps, nothing. Now, I have not put any water in yet. Yes, I know the pumps can burn out, just wanted to see if it was going to turn on, then I was going to kill power right away. now, could the lack of water, cause the nothing happening?? Safety switch???? Or is my control board most likely DOA. Please, no flames here, I am new and just looking for some help. The spa is in beautiful condition, and I don't want to start all over. Oh Yea, I know its a balboa spa, but I don't have any manual for it. Thanks for all the help in advance.


Dan

Title: Re: New to Hot tubs, need some help getting it started
Post by: Tman122 on May 27, 2015, 09:19:14 pm

Who did the electrical? Is it hooked up properly?

Title: Re: New to Hot tubs, need some help getting it started
Post by: Rodder98 on May 27, 2015, 10:21:58 pm

a licensed electrician. Yes, it is hooked up properly.

Title: Re: New to Hot tubs, need some help getting it started
Post by: Dr. Spa™ Ret. on May 27, 2015, 11:44:58 pm

Balboa makes electrical controllers.

Title: Re: New to Hot tubs, need some help getting it started
Post by: Tman122 on May 28, 2015, 07:29:10 pm

OK are there any fuses on the control board?