Hot Tub Forum
Original => Hot Tub Forum => Topic started by: RLJ on May 16, 2015, 10:56:58 am
-
I have a Tiger River that recently will not heat completely to temperature. Only gets warm. Have changed filters and reset tube. What could the problems be?
-
You should check the voltage to the heater and confirm it's getting 220v. If so then it's most likely a bad element or maybe in an economy mode and only heating during a filter cycle. If it's not getting power you need to find out why not.
Bad board, temp sensor or pressure switch possibly something else . Any error codes on the display?
-
No error codes. It acts like it is at the correct temp but is 10 degrees lower