Hot Tub Forum

Original => Hot Tub Forum => Topic started by: Nordicuser on May 30, 2013, 06:59:33 pm

Title: Tub throws FL code after every stop
Post by: Nordicuser on May 30, 2013, 06:59:33 pm

Newbie to the forum.  Have a '98 Nordic DLX with a balboa controller.  Every time the tub goes through a cycle it throws an FL code after the cycle is done.  I know this is a flow problem and have changed the filter and verified that everything is plugged in right and getting the right voltage.  Do I need to replace the board or is there something I'm missing?

Title: Re: Tub throws FL code after every stop
Post by: Hottubguy on May 30, 2013, 08:17:10 pm

I think on that tub you need to change out the board. Pretty sure the flow switch is built into the board.

Title: Re: Tub throws FL code after every stop
Post by: Nordicuser on May 31, 2013, 09:12:30 am

I called around to balboa dealers no one can match up my part # 27100_P.  Any ideas?

Title: Re: Tub throws FL code after every stop
Post by: Hottubguy on May 31, 2013, 05:55:24 pm

Call 1-888-Get-Tubs and push 8 Rodney or Shawn will answer and if there are no Nordic dealers nearby they will sell you the part needed