Hot Tub Forum
Original => Hot Tub Forum => Topic started by: hottbpete on April 20, 2013, 01:18:37 pm
-
Hi Gang- been a long time
I have a Niagra
I was changing water, emptied refilled and then started the chemicals when I went to use the clean mode, I could here the motor come on but no water from the jests. I then tried motor1 and motor 2. 2 is a two speed and works fine, one does the same. I am assuming one and clean are using the same pumps. Air works fina also. any ideas on why you would here the pump but no jet water?
Thanks
BTW it was working fine before the water change.
Pete 8)
-
Hi Gang- been a long time
I have a Niagra
I was changing water, emptied refilled and then started the chemicals when I went to use the clean mode, I could here the motor come on but no water from the jests. I then tried motor1 and motor 2. 2 is a two speed and works fine, one does the same. I am assuming one and clean are using the same pumps. Air works fina also. any ideas on why you would here the pump but no jet water?
Thanks
BTW it was working fine before the water change.
Pete 8)
You have an air lock. You need to loosen the upper nut on the pump a little at a time until you hear air escape.
-
Thanks, I will try it....when I figure out how m :)
-
Hi Gang- been a long time
I have a Niagra
I was changing water, emptied refilled and then started the chemicals when I went to use the clean mode, I could here the motor come on but no water from the jests. I then tried motor1 and motor 2. 2 is a two speed and works fine, one does the same. I am assuming one and clean are using the same pumps. Air works fina also. any ideas on why you would here the pump but no jet water?
Thanks
BTW it was working fine before the water change.
Pete 8)
There's a small bleeder nut (square) on the top or side of the pump that when loosened will expel air until water flows. Be prepared to close it quickly to avoid a mess. Next time make sure to fill through the filter.
-
There's few reasons why this is happening..
Air lock in suction line - Check horizontal piping between well and pump. If it does not pitch upward from well to pump, an air lock may form. Rearrange piping to eliminate air lock.
Low well level - Check well depth against pump performance table to make sure pump and ejector are properly sized. If undersized, replace pump or ejector.
Leak in air volume control or tubing - Disconnect air volume control tubing at pump and plug hole. If capacity increases, a leak exists in the tubing of control. Tighten all fittings and replace control if necessary.
This is where I check parts I need - great deals! http://www.gopoolandspa.com/Pumps-Circulation/