Hot Tub Forum

Original => Hot Tub Forum => Topic started by: xring600 on April 15, 2013, 06:46:40 am

Title: Viking II Spa Quits Running Then Starts Again
Post by: xring600 on April 15, 2013, 06:46:40 am

 I have a Viking II spa that shuts off and displays the error 6y of dy on the control panel. I hit the jet button and it will almost always start running again and heat back to 102. Any ideas? Thanks.

Title: Re: Viking II Spa Quits Running Then Starts Again
Post by: bimmerdog on April 15, 2013, 11:14:44 am

 click  and scroll down to page 12 it has your answer      http://vikingspas.com/2012englishownersfinal.pdf

Title: Re: Viking II Spa Quits Running Then Starts Again
Post by: xring600 on April 15, 2013, 05:03:53 pm

Thank you! Cant figure this one out as my water level is good. Time to investigate further.

Title: Re: Viking II Spa Quits Running Then Starts Again
Post by: Hottubguy on April 15, 2013, 07:44:27 pm

That code usually means not enough flow through heater. Pull the filter out and see if the problem persists

Title: Re: Viking II Spa Quits Running Then Starts Again
Post by: Spatech_tuo on April 16, 2013, 02:11:45 pm

Quote from: Hottubguy on April 15, 2013, 07:44:27 pm

That code usually means not enough flow through heater. Pull the filter out and see if the problem persists

Hopefully just an old filter.

Title: Re: Viking II Spa Quits Running Then Starts Again
Post by: xring600 on April 19, 2013, 06:50:34 am

Took filters out and am still having the same problem. Except now the pump will not start at all........only get a humming noise when I press the jet button on my overhead control.