FLO Error

[lskarp]

OK, first problem!!!

I went to crank up the heat when I got home from work and I was greeted to a FLO display on my Vita Nuage.  The book says it is a flow error.  I pulled and rinsed both filters which appeared clean as I dumped the water 2 weeks ago and did a dishwather run with them after using the Leisure Time spray cleaner.

No luck, so I left the filter off and tried again, and still had a FLO error.  The jet pumps work fine, but teh circ which I have on 24X7 does not seem to be on and flowing.

I will call the dealer tomorrow, but I woudl like to go in tonight!!

Any ideas??

[Vinny]

Turn off the tub, wait about 5 minutes and turn it back on ... maybe the electronics got confused.

[lskarp]

Did that 2X.  Now I am in teh wait 30 mins mode, then I may try a factory reset.

There is always teh dealer, but then we are looking at a coupld of days b4 I get to go back!!

[George]

I have heard some have reported getting FLO problems with an Air Lock.

[lskarp]

I jammed the garden hose in the pipe with a towel wrapped around it and tiny ozone looking bubbles came out of teh filter outlet port.  I am thinking it is a terminal thing for teh Circ pump or the underlying electrics.  I am under warranty, so they will look at it and repair.

Any more ideas, let me know.

THX all!!

[Brewman]

You did the right thing.
You've eliminated the likely culprits, filter and airlock, and now it's probably down to a mechanical issue.  On my spa it was a bad circ. pump- falied about a year ago.  
 Could be anything that is causing the FLO switch to trip.

[lskarp]

I am figuring as much.  I called my dealer and he is geting a guy out.  They usually take 1 - 2 days to actually call and show.  I figure that we are looking at a circ pump connection or mechanical problem.  

So far no hassle from the dealer.  

Total bummer though as I am moving 200 people into a new office on Friday, and I can sure use the spa!!!

THX all,

LK