What's the Best Hot Tub

Author Topic: Question on direction of cover lift  (Read 1915 times)

Tatooed_Lady

  • Senior Member
  • ****
  • Posts: 1386
  • Participating in the Witness Protection Program
Question on direction of cover lift
« on: March 19, 2006, 06:21:43 pm »
Ok, the basics needed: HS Grandee, Glide Rite cover lift.
do I need arm clearance for the lift anywhere but at the end of the tub where the cover will rest? Asking because the deck we just built is slightly larger than the tub, and I'm trying to figure out how centered we'll be able to be, after all is said and done.....Yes, I know I could wait and find out when it's delivered, but I like knowing the basics beforehand.....and dealer closed at 3, so I can't ask them til tomorrow. ;)
RIP C-Rod

Hot Tub Forum

Question on direction of cover lift
« on: March 19, 2006, 06:21:43 pm »

SurgTec

  • Junior Member
  • *
  • Posts: 83
  • Up to my neck in hot water!
Re: Question on direction of cover lift
« Reply #1 on: March 19, 2006, 08:21:50 pm »
I have a Marquis spa and use a 'cover butler' type lifter.  The orientation of the lifter was determined by two factors for me.  One - my spa is a rectangle and the lifter would only fit on one dimension.  Two - I could either have the cover block my view (lift to pool/ outside) or I could have it lift to the rear of the spa.  I chose to lift to the rear of the spa - it makes getting around the spa when it is open a bit of a squeeze - but worth it.

So, FWIW, my answer to your question is - clearance and view may be your deciding considerations.

Snowbird

  • Full Member
  • ***
  • Posts: 435
  • What did he say?
Re: Question on direction of cover lift
« Reply #2 on: March 20, 2006, 06:13:45 am »
Morning T-Lady...

I have a Coverlift 1.  The hinges add about 4.5 inches to sides and it takes about 14 inches for cover clearance.

Doc has a nice table on his site to helpwith these things.

http://www.rhtubs.com/coverlifts/lift-configurater.htm
« Last Edit: March 20, 2006, 06:16:49 am by Snowbird »
The World Champion Pittsburgh Steelers

Tatooed_Lady

  • Senior Member
  • ****
  • Posts: 1386
  • Participating in the Witness Protection Program
Re: Question on direction of cover lift
« Reply #3 on: March 20, 2006, 08:25:53 am »
Wow....I FINALLY found (sort of) what I was looking for....I haven't run across this particular lift showing what side clearance is required, but it looks like I can work this in VERY easily......Thanks for your replies, SurgTec and Snowbird!

Glide Rite lift, apparently designed by HS for HS tubs...
RIP C-Rod

Hot Tub Forum

Re: Question on direction of cover lift
« Reply #3 on: March 20, 2006, 08:25:53 am »

 

Home    Buying Guide    Featured Products    Forums    Reviews    About    Contact   
Copyright ©1998-2024, Whats The Best, Inc. All rights reserved. Site by Take 42