Author Topic: Pump Seal (Read 3500 times)

countryboy · « **on:** July 11, 2005, 03:17:08 pm »

What will cause a Pump seal to fail? water chemistry is in the limits. There is a white crust around the seal and in the pan under the pump. Its an itermiten leak.

Hot Tub Forum · « **on:** July 11, 2005, 03:17:08 pm »

Spatech_tuo · « **Reply #1 on:** July 11, 2005, 04:14:48 pm »

Quote

What will cause a Pump seal to fail? water chemistry is in the limits. There is a white crust around the seal and in the pan under the pump. Its an itermiten leak.

How old is it?

SDguy · « **Reply #2 on:** July 11, 2005, 04:20:03 pm »

The white stuff is probably minerals (calcium). That would help make it brittle and thus causing it to leak. Make sure your using a water softenner or some type of scale control in the water.

J._McD · « **Reply #3 on:** July 11, 2005, 05:33:27 pm »

several things will cause a pump seal to leak. 1 = Friction, running the pump for a period of time without water, such as an air lock creats heat by friction. 2 = water chemistry and acidic chemicals.

Should you discover a pump seal leak it is less than a $100 repair, if neglected it becomes a $500 repair.

The white salts are residual chemicals from the water the leaked through and evaporated leaving the chemical and mineral content behind as evidence.

Chas · « **Reply #4 on:** July 11, 2005, 05:58:42 pm »

Quote

several things will cause a pump seal to leak. 1 = Friction, running the pump for a period of time without water, such as an air lock creats heat by friction. 2 = water chemistry and acidic chemicals.

Should you discover a pump seal leak it is less than a $100 repair, if neglected it becomes a $500 repair.

The white salts are residual chemicals from the water the leaked through and evaporated leaving the chemical and mineral content behind as evidence.

I agree.

Most common cause of this failure is low pH or keeping a floating feeder in the skimmer.

countryboy · « **Reply #5 on:** July 12, 2005, 06:52:32 am »

PH, Alk are all in the limits, no floater, Hardness is where is should be. The tube is a year old. Never ran with out water or bleeding system first. Maybe just a bad seal from factory?

HotTubMan · « **Reply #6 on:** July 12, 2005, 09:43:35 am »

Quote

PH, Alk are all in the limits, no floater, Hardness is where is should be. The tube is a year old. Never ran with out water or bleeding system first. Maybe just a bad seal from factory?

Very possible. Get it fixed before you corrode the bearings or worse.

countryboy · « **Reply #7 on:** July 12, 2005, 11:02:36 am »

Already fixed, they installed a new pump not just the seal.

jsimo7 · « **Reply #8 on:** July 12, 2005, 11:28:43 am »

Good deal that is is fixed, Replacing the entire pump is good for you to insure no problems later because of this defect

Hot Tub Forum · « **Reply #8 on:** July 12, 2005, 11:28:43 am »

Hot Tub Forum

News: