What's the Best Hot Tub

Author Topic: Help! Moved Sundance Optima, GFCI trips  (Read 3262 times)

regulajo

  • Guest
Help! Moved Sundance Optima, GFCI trips
« on: July 06, 2005, 02:38:52 am »
I just had my Sundance Optima moved by the dealer to a new home and while filling it the GFCI trips. It seemed to trip about the time the water hit the seat level (just above the footwell). Could something have become wet during the move, tipping the tub on it's side, etc.? Should I give it a day or two to dry? Or look at other possible causes?
Thanks for any help!

Hot Tub Forum

Help! Moved Sundance Optima, GFCI trips
« on: July 06, 2005, 02:38:52 am »

SerjicalStrike

  • Full Member
  • ***
  • Posts: 796
  • Reinstate Hank Williams!!
    • Great Bay Spa and Sauna
Re: Help! Moved Sundance Optima, GFCI trips
« Reply #1 on: July 06, 2005, 08:26:18 am »
1) you should never turn you breaker on until the tub is full.

2) if the movers tipped the spa on the (if you are looking at the control panel) left and side or put the control panel side face down, there could be water in the air blower.  

regulajo

  • Guest
Re: Help! Moved Sundance Optima, GFCI trips
« Reply #2 on: July 06, 2005, 10:39:44 am »
SerjicalStrike,
Thanks for your response.
Yes, they did turn it on the left side to load it and the right side to unload it. (Had to make sure water got everywhere.) Do you think time will allow it to dry out and then try again, or would this tipping have caused some other type problem?
Thanks again.

Steve

  • Ultimate Member
  • *****
  • Posts: 3196
Re: Help! Moved Sundance Optima, GFCI trips
« Reply #3 on: July 06, 2005, 11:06:34 am »
I'm not sure why the GFI was turned on while the tub was empty? Is that what happened? ???

If that's the case, you might have burnt your heater element.

Steve

SerjicalStrike

  • Full Member
  • ***
  • Posts: 796
  • Reinstate Hank Williams!!
    • Great Bay Spa and Sauna
Re: Help! Moved Sundance Optima, GFCI trips
« Reply #4 on: July 06, 2005, 05:12:12 pm »
I doubt the heater element is burnt out as there would have been no reason for the element to turn on.

As far as the blower goes, you can take it out and dry it off and dry off the inside of the blower compartment.  This may do the trick, it may not.

mjb

  • Full Member
  • ***
  • Posts: 208
Re: Help! Moved Sundance Optima, GFCI trips
« Reply #5 on: July 06, 2005, 07:31:04 pm »
When you moved your Optima if the air blower
was on the "downhill" side water in the lines
may have gone around the plumbing loop
and entered the motor.  
Try to disconnect the air blower and see if the breaker
remains on.
Please turn the power off at the main breaker or at
the disconnect first.

regulajo

  • Guest
Re: Help! Moved Sundance Optima, GFCI trips
« Reply #6 on: July 07, 2005, 12:23:15 am »
MJB,
You're right on the money! I disconnected the the blower wires and turned the power back on again, and sure enough it is running fine, it was already up to a balmy 69 degrees, from a start of 57.  If I just leave the blower for a few days - week to dry out, will it? I hate to take it apart to dry it.
I also wanted everyone to know that standing and waiting for the spa to warm up doesn't mean it goes any faster. :(
Thanks to everyone for their help.

wmccall

  • Global Moderator
  • Mentor Level Member
  • *****
  • Posts: 7431
    • https://www.facebook.com/BillMcCall1959/
Re: Help! Moved Sundance Optima, GFCI trips
« Reply #7 on: July 07, 2005, 09:05:52 am »
Quote
When you moved your Optima if the air blower
was on the "downhill" side water in the lines
may have gone around the plumbing loop
and entered the motor.  
Try to disconnect the air blower and see if the breaker
remains on.
Please turn the power off at the main breaker or at
the disconnect first.


Great job MJB!
Member since 2003.  Owner Dynasty Excalibur 2003-2012.   Sundance Majesta from 2012-current

mjb

  • Full Member
  • ***
  • Posts: 208
Re: Help! Moved Sundance Optima, GFCI trips
« Reply #8 on: July 07, 2005, 12:38:51 pm »
Not sure that it will dry out.
Probably shorted-out.
You could take the assembly apart
and go to your local dealer and
pick-up a new motor for around
$ 100

Hot Tub Forum

Re: Help! Moved Sundance Optima, GFCI trips
« Reply #8 on: July 07, 2005, 12:38:51 pm »

 

Home    Buying Guide    Featured Products    Forums    Reviews    About    Contact   
Copyright ©1998-2024, Whats The Best, Inc. All rights reserved. Site by Take 42