What's the Best Hot Tub

Author Topic: Slope at install site  (Read 2312 times)

cchaynes

  • Junior Member
  • *
  • Posts: 7
Slope at install site
« on: August 29, 2019, 12:51:49 pm »
Hey everyone

We will be receiving our tub next month and it will sit on a paving stone patio.  It slopes away from the house for obvious reasons, and i would consider the slope to be average.

The rise over run is 1 in over 6 ft (72")

My dealer feels this will be fine, do you guys concur?

Thanks
Craig

Hot Tub Forum

Slope at install site
« on: August 29, 2019, 12:51:49 pm »

Sam

  • Senior Member
  • ****
  • Posts: 1335
Re: Slope at install site
« Reply #1 on: August 29, 2019, 02:16:22 pm »
That's pushing it.  It won't hurt the hot tub but the difference in water height will probably be annoying.  There is a guy in kansas who makes "the spa level-r" that a few of my customers have purchased and had good luck with.

Spatech_tuo

  • Mentor Level Member
  • ******
  • Posts: 6340
Re: Slope at install site
« Reply #2 on: August 30, 2019, 12:14:40 am »
That is pushing it and it will depend on where the filter section is, it has to be on the "deep" end.
220, 221, whatever it takes!

swilly1000

  • Full Member
  • ***
  • Posts: 307
Re: Slope at install site
« Reply #3 on: August 30, 2019, 12:17:10 am »
Yep. Level it for sure.

Hot Tub Forum

Re: Slope at install site
« Reply #3 on: August 30, 2019, 12:17:10 am »

 

Home    Buying Guide    Featured Products    Forums    Reviews    About    Contact   
Copyright ©1998-2024, Whats The Best, Inc. All rights reserved. Site by Take 42