What's the Best Hot Tub

Author Topic: OPTIMA 880 CONTROL PA HELP  (Read 1882 times)

AMMOT23

  • Junior Member
  • *
  • Posts: 3
OPTIMA 880 CONTROL PA HELP
« on: January 16, 2019, 10:59:24 am »
quick question,my control pad on my sundance optima is lit ,but no readout,i do only get the heat icon and the change filter icon,there is also no function from any of the buttons,the tub is still heating,any simple trouble shooting suggestions i believe it is a 2007 optima sundance thanks in advance

Hot Tub Forum

OPTIMA 880 CONTROL PA HELP
« on: January 16, 2019, 10:59:24 am »

Sam

  • Senior Member
  • ****
  • Posts: 1335
Re: OPTIMA 880 CONTROL PA HELP
« Reply #1 on: January 17, 2019, 10:47:55 pm »
Sounds like a bad topside but you could always follow the cable underneath, unplug it and reset the spa.  Doubt that will work but I have seen it work in the past.  They can work loose over time if they weren't fully plugged in to begin with. 

AMMOT23

  • Junior Member
  • *
  • Posts: 3
Re: OPTIMA 880 CONTROL PA HELP
« Reply #2 on: January 18, 2019, 12:25:51 pm »
thanks so much,i did unplug it but I did not reset while it was unplugged, I will try that,if you were a gambling man would you think pad or board is bad,thanks in advance

Jacuzzi Jim

  • Ultimate Member
  • *****
  • Posts: 3584
Re: OPTIMA 880 CONTROL PA HELP
« Reply #3 on: January 18, 2019, 09:11:38 pm »
 90% sure it's a bad top side.

Hot Tub Forum

Re: OPTIMA 880 CONTROL PA HELP
« Reply #3 on: January 18, 2019, 09:11:38 pm »

 

Home    Buying Guide    Featured Products    Forums    Reviews    About    Contact   
Copyright ©1998-2024, Whats The Best, Inc. All rights reserved. Site by Take 42