2016 caldera vanto
So yesterday, as I am still trying to troubleshoot my GFCI tripping problem, I pulled the board out to inspect it. Board looked fine so I put it back in, attached all wires, and ensured the setup was correct (software jumpers). Fired it it, and all worked.
Today I went out to check on it. Pump 1 low speed works, but when i push pump 1 high speed I get a ===== code with READY and JETS flashing and the pump cuts off. When i push Jets again, pump 2 comes on just as it should. Therefore, pump 1 high speed is the only thing not working (not even a year since this). This happened previously and the pump was replaced under warranty. The manual says the code means the pressure switch is open. Why would this happen all of a sudden? Or is there another meaning to the code
Hot tub is at the correct temperature..
Also - does ANYONE have any service manual information on these tubs. There is literally nothing on the internet. I cant stand not being able to troubleshoot or know what the jumpers mean, etc.
