Hello all, just new to this forum. I've been scouring the Net for the past few days and trying to figure the issue with the used tub I just purchased. Its a Pacific spa with the stealth system. At first the GFCI kept kicking out so I unplugged one of the colored plugs at a time and tried again. Eventually I was able to get it to run with one plug undone. I can plug this one back in once its running but it causes the water to run up the filter housing and out from under the lid- don't think this is a 'water feature' because there's and overflow tube that then starts to leak. If I leave it unplugged, I can remove the filter while running and can't feel any suction or pressure where the filter was. The water circulates but I don't see the water being drawn from the main filter basket either...both motors seem to be running, I took the heater apart and the element registers 14.5 ohms but only will kick on for a short time if I manually depress the temperature switch. I disconnected the switch and tried bypassing it and the heater still wasn't kicking in.
Any ideas? Thanks so much!
