Welcome to our forum.
Hi allGot my new hot tub Saturday and am having it wired up soon. I got a chemical pack containing the following:Dispenser with bromine tabletsSpa clarifierFilter cleanerSpa no foamChlorine granulesPh plusPh minusWhen it's been filled with water what chemicals do I add? I know I have to wait 12 hours after adding chemicals plus for water to heat up.Also what's best way to empty it? I was going to use drain valve but heard it takes ages. My tub also leaves a lot of water in the foot well. I can only think of using a submersible pump which will hardly leave much water.Cheers guys
Thanks for your replyTest resultsPh 6.2alkalinity 80chlorine 0ppm stabilizer 0Not sure if this helps at all but its a link to water quality in my areahttp://www.unitedutilities.com/waterquality.aspx?postcode=ch66+1tx
Quote from: Mike710_0 on September 11, 2013, 07:09:56 amThanks for your replyTest resultsPh 6.2alkalinity 80chlorine 0ppm stabilizer 0Not sure if this helps at all but its a link to water quality in my areahttp://www.unitedutilities.com/waterquality.aspx?postcode=ch66+1txAfter your PH Plus is gone, I use cheap baking soda in the small boxes to raise my PH up.
I don't even know where to find Soda Ash, I should try that.