flo error - gecko artic spa

[Water Boy]

theres no pressure switch guys

If he has a Arctic Spa, then there should most definitely be a pressure switch...

[Ryan VSO]

Geez guys theres no pressure switch in.xe if its not working you have to change the pack but i doubt that this is the problem as in.xe are very reliable

[Water Boy]

Well. maybe I don't know what I am talking about then . I know here in the US, every Gecko pack we have out there has pressure switches with them. I am guessing that this version of Gecko may be a European version, which doesn't require pressure switches. It that is the case, then it most likely is the capacitor on the motor then.

[Ryan VSO]

old gecko pack ( m-class or s-class ) does have pressure switch but the new generation ( in.xe & in.xm ) does not .

[Water Boy]

old gecko pack ( m-class or s-class ) does have pressure switch but the new generation ( in.xe & in.xm ) does not .

Yes I went and did some digging, and you are correct Vortex. Please accept my apologies. I am obviously not familiar with the in.xe spa packs. We don't sell the new Gecko packs any more, and exclusively use the Arctic Eco packs, so I am not up to speed on the new versions of Gecko. My bad for assuming!

 I am pretty confident that this is the capacitors in the motor after learning this now. Thanks for correcting me!!

[hawkella]

Pressed no.1 pump switch for over a minute all I got wad L4. My in.xe manual says that L will show up but says nothing about LL

[Ryan VSO]

l4 is the good setting for your system . on the xe , those sensor can get blind because of the calcium accumulation , you can find a product to clean it , make sure you dont have any air lock tho

[hawkella]

Yep I will clean it. It will take a few days - I will post how it goes. Thanks for your help

[hawkella]

I changed the low speed capacitor for the pump, uninstalled the in.flo sensor the reinstalled and touch wood all seems fine. I believe it was yhe capacitor . Thx for the help and hope this helps someone