Author Topic: Tub throws FL code after every stop (Read 2528 times)

Nordicuser · « **on:** May 30, 2013, 06:59:33 pm »

Newbie to the forum. Have a '98 Nordic DLX with a balboa controller. Every time the tub goes through a cycle it throws an FL code after the cycle is done. I know this is a flow problem and have changed the filter and verified that everything is plugged in right and getting the right voltage. Do I need to replace the board or is there something I'm missing?

Hot Tub Forum · « **on:** May 30, 2013, 06:59:33 pm »

Hottubguy · « **Reply #1 on:** May 30, 2013, 08:17:10 pm »

I think on that tub you need to change out the board. Pretty sure the flow switch is built into the board.

Nordicuser · « **Reply #2 on:** May 31, 2013, 09:12:30 am »

I called around to balboa dealers no one can match up my part # 27100_P. Any ideas?

Hottubguy · « **Reply #3 on:** May 31, 2013, 05:55:24 pm »

Call 1-888-Get-Tubs and push 8 Rodney or Shawn will answer and if there are no Nordic dealers nearby they will sell you the part needed

Hot Tub Forum · « **Reply #3 on:** May 31, 2013, 05:55:24 pm »

Hot Tub Forum

News: