2001 Landmark wiring

[ovfd16]

Ok I got a new board for my Landmark but know I need the wiring advice again since my TB1 terminal has six locations but the wiring diagram only shows five. I have the wires coming from the sub panel and the two large black and white wires for the heater. The white goes off to the side of the TB1 into another terminal but the black goes in one of the six spots and I not sure where.

Please help.

[Jacuzzi Jim]

 A picture is worth a 1000 words! 

[ovfd16]

The forum insert image is not allowing me to upload photos. Could I email them to you Jacuzzi Jim? Can you send me your email address?

[Chas]

If we are talking about a Heater Relay Board, (HRB) then look in the box it was shipped in: there are complete instructions.

But the thing you mentioned: one more connector is wrong: there are TWO more connectors. One is in the block along with the others, and you must notice that the numbers are different: 1, the H1, then 2, 3, 4, 5. The H1 is one of the two terminals for the heater. The other, H2, is off on it's own to the left of the power block.

HTH

 

[sorebikr]

The forum insert image is not allowing me to upload photos. Could I email them to you Jacuzzi Jim? Can you send me your email address?

I've had that problem in the past.  Try uploading the pics to any of the free sites out there like http://imgur.com/ and you can then post the links to the pics here. 

[Chas]

H1 and H2 are for the heater. Clip off the connectors and clamp the wires for the heater into the H spots. No polarity, either wire in either slot.

HTH