"Watchdog" Panel Display

[Skellman]

Hello all,

Hopefully somebody can give me some input. I'm guessing I'll need to have a tech come in.
Anyway, the display on my Sundance Hamilton is showing - - - which indicates a "watchdog" safety software has been triggered.

Any ideas or should I get the tech scheduled?

Thanks

[mjb]

Try turning off the power to the spa at
either the breaker or disconnect, then
wait 20 minutes and turn the power
back on. 
Hopefully this will clear the problem.

[Skellman]

I already did that but only for a few seconds did I cut the power.

I'll try it and leave it off for 20 minutes.
And pray that does it.
Thank you.

[Skellman]

Turned the breaker off for over an hour. Fired it up and same thing.
It runs for a minute or so. While running the display flashes between "ice" and the water temperature.
It then shuts down and goes back to the - - -.

Any other suggestions?

[Jacuzzi Jim]

 Could be a couple things, circ pump, temp sensor or flo switch.   Most likely circ pmp or temp sensor. Check the circ pump first.