I have a Tiger River Spa made by Watkins. Sumatran Model N, and has a Watkins no fault 6000 heater, and a IQ 2000 Inside Control System, other spec's on the inside control panel is SIEB model 100-01212-01 part # 37307. The spa has been sitting empty on my deck for a year now, and was winterized. Filled up and made sure there was no air in the lines. Jets all work. When I plugged the spa in I heard 1 click and then another. Then I got a solid red light on the control panel, along with NO green ready light, because temp is not ready, and then the ready light starts to blink. On the inside main circuit board when first plugged in I get green LIM on light, a red light on the heater on light, and no red light in the control on the unplugged light. When the jets are turned on the red light on the heater light goes out inside the control box, and I hear a another click. I unplugged for 1 min. and plugged back in, and got the same results. Then I pushed the reset breaker on the heater again nothing. I feel a little heat when I touch the tubing from coming out of the heater. When jets are first turned I feel a little hot water coming from the jets, and the bottom Heat Return Spa Drain. When spa is rest and the jets are off I can't feel water circulating through the bottom drain. It is hard to tell but the circulating pump may not be working. Could this be the cause of my problems? Is there a way to reset the circulation pump? Is there a way to test the circulation pump without taking it out. I hope this makes sense.
George