What's the Best Hot Tub
Home Buying Guide Featured Products Forums Reviews About Contact
Sign up  |  Log in
« previous next »
Pages: [1]

Author Topic: Removing wires from terminal block  (Read 6563 times)

bearpeidog

  • Junior Member
  • *
  • Posts: 3
Removing wires from terminal block
« on: October 25, 2009, 03:41:54 pm »
Hell- on a host spring terminal block, how do you remove the wires?  It looks like the are pressure clamped through the terminal holes, but can't seem to figure out how to release them.  Thanks!


Logged

Hot Tub Forum

Removing wires from terminal block
« on: October 25, 2009, 03:41:54 pm »

bearpeidog

  • Junior Member
  • *
  • Posts: 3
Re: Removing wires from terminal block
« Reply #1 on: October 25, 2009, 03:54:45 pm »
Found the answer - posting here in case someone else is looking for it...
You take a small screw driver and pry up in the small square hole located above the wire.  Wire will pop right out.

To insert wire, do the same thing.  Pry up and insert wire.


Logged

Hot Tub Forum

Re: Removing wires from terminal block
« Reply #1 on: October 25, 2009, 03:54:45 pm »
Pages: [1]
« previous next »
 
Home    Buying Guide    Featured Products    Forums    Reviews    About    Contact   
Copyright ©1998-2024, Whats The Best, Inc. All rights reserved. Site by Take 42