Welcome to our forum.
If your spa tends to go high in pH, then lower the TA level. If you try and keep a higher TA level then the pH will tend to rise and you'll be in a catch-22. You basically need to adjust your TA to a level where the pH is roughly stable. There is no single TA level recommendation one can give for this since it depends on the chemicals you are adding to the spa and on the amount of aeration. Generally speaking, when using Dichlor or some MPS brands, then a higher TA level (100-140 ppm) is needed to keep the pH stable. When using a hypochlorite source of chlorine (e.g. bleach), then a lower TA level (60-80 ppm) is needed to keep the pH stable.Pools and spas are intentionally over-carboanted and Total Alkalinity (TA) is mostly a measure of that carbonation (technically, it mostly measures bicarbonate). Just as a carbonated beverage that you stir will outgas carbon dioxide and lose its carbonation, the same is true for a pool or spa. This outgassing causes the pH to rise (and the TA to remain the same for technical reasons I won't get into here). When you add acid to the water, this lowers both the pH and the TA. This is why adding acid and aerating is an easy way to lower the TA (especially if this is done at a lower pH which makes the process go faster).If you want to balance your saturation index, then you adjust your calcium hardness (CH) last, after you've adjusted your TA to get your pH to be stable.Richard