What's the Best Hot Tub

Author Topic: Electrical Setup Costs  (Read 5949 times)

RK23

  • Junior Member
  • *
  • Posts: 64
Electrical Setup Costs
« on: October 24, 2007, 02:24:21 pm »
Could folks share what the expected or actual costs were for an electrician to set up a hot tub?  The distance from the main electrical box to the GFCI sub panel is about 30ft of unfinished basement.  The distance from the GFCI sub panel to the hot tub is about 15 ft, under a deck.

I live in New England, but would be interested in both labor and material estimates no matter where you live.  Please note that I already have the GFCI sub panel, which comes with the hot tub.

Thanks

Hot Tub Forum

Electrical Setup Costs
« on: October 24, 2007, 02:24:21 pm »

cburk0677

  • Full Member
  • ***
  • Posts: 162
Re: Electrical Setup Costs
« Reply #1 on: October 24, 2007, 02:35:56 pm »
I live in Indy and my electric was base charge of $450 which included 40ft of wiring. Additional ft was $8 a foot. I had a fairly long run so my total install was around $900.00
Enjoying SpaTopia in my 2006 Hotspring Vanguard

tinybubbles

  • Full Member
  • ***
  • Posts: 179
Re: Electrical Setup Costs
« Reply #2 on: October 24, 2007, 02:40:09 pm »
We did it ourselves.  The GFCI was $90.  We paid a little over $3.00 a ft. for the wire.  Then there was the cost for conduit and fittings, but this wasn't much so I don't remember.  Around here, the general rule of thumb is that electricians will charge the same amount for the labor that the materials cost...so $250 materials, $250 for labor....$500 total.  I have seen people on here with quotes all over the place for the same job.  

96SC

  • Full Member
  • ***
  • Posts: 611
Re: Electrical Setup Costs
« Reply #3 on: October 24, 2007, 02:47:18 pm »
I'm in the deep south.  We recently had our sevice ran and had the sub panel that came with the spa.  From our electrical box to the sub panel was about 45 feet (all outside in plastic conduit), from the sub panel to the spa with wiring (again in plastic conduit) ran under a new patio was about 20 feet.  (The electrician layed all the conduit).  Total came to $585.00.
The electrician is the designated installer for the dealer we bought our spa from which may have helped cost-wise.

Hope this helps, but the south is usually cheaper than in New England, California, Chicago...just about anywhere.
Before I speak, I have something important to say--Groucho Marx

RK23

  • Junior Member
  • *
  • Posts: 64
Re: Electrical Setup Costs
« Reply #4 on: October 24, 2007, 02:49:32 pm »
Thanks for the quick responses.  My quote is just over $800, which seems like it's in the ballpark, considering I'm in Massachusetts.

96SC

  • Full Member
  • ***
  • Posts: 611
Re: Electrical Setup Costs
« Reply #5 on: October 24, 2007, 02:57:04 pm »
Quote
in the ballpark ..... I'm in Massachusetts.

[size=16]Go Rockies[/size]  Sorry, RK.
Before I speak, I have something important to say--Groucho Marx

Jacuzzi Jim

  • Ultimate Member
  • *****
  • Posts: 3584
Re: Electrical Setup Costs
« Reply #6 on: October 24, 2007, 02:59:17 pm »
 Average in the Pac N,West is 8 to 1200.00

Dr. Spa™ Ret.

  • Ultimate Member
  • *****
  • Posts: 3377
  • Retired (mostly) from the industry after 33 years
Re: Electrical Setup Costs
« Reply #7 on: October 24, 2007, 03:04:57 pm »
8 is pretty good. The lowest I ever did was $20, and I once bid a job at $3000 (while I was the lowest bid, the customer decided not to get a spa at all).
If you can't sell it on eBay, it may not even qualify as landfill.

Retired (mostly) from the industry after 33 years...but still putzing around with a consumer information website, and trying to sell obsolete owners manuals

loosenupspas

  • Full Member
  • ***
  • Posts: 296
Re: Electrical Setup Costs
« Reply #8 on: October 24, 2007, 03:09:01 pm »
In Florida, the breaker and other hardware is $310.....4 wire & 6 guage is $7.00 per foot above ground and up to $11.00 if trenching is involved.

Dr. Spa™ Ret.

  • Ultimate Member
  • *****
  • Posts: 3377
  • Retired (mostly) from the industry after 33 years
Re: Electrical Setup Costs
« Reply #9 on: October 24, 2007, 03:58:45 pm »
Gotta love digging in sand.
If you can't sell it on eBay, it may not even qualify as landfill.

Retired (mostly) from the industry after 33 years...but still putzing around with a consumer information website, and trying to sell obsolete owners manuals

Vanguard

  • Senior Member
  • ****
  • Posts: 1140
Re: Electrical Setup Costs
« Reply #10 on: October 24, 2007, 05:17:37 pm »
Quote
Thanks for the quick responses.  My quote is just over $800, which seems like it's in the ballpark, considering I'm in Massachusetts.

Always costs more when unions get involved.  
The stars at night are big and bright, deep in the heart of Texas and my Vanguard!!!

Doobiewah

  • Junior Member
  • *
  • Posts: 61
Re: Electrical Setup Costs
« Reply #11 on: October 24, 2007, 05:37:04 pm »
Hello,

I've gotten four quotes to go from a box, 100' through a ceiling, then into a GFCI Breaker box, then another 10' under a deck to the spa.  The bids ranged from $700 to $1200.  This is in Flagstaff, AZ.  The cheapest quote was the smallest (owner and one assistant) company.  The highest was from the biggest electrical contractor in town.  My neighbor, a local developer, told me to call a couple of small guys as they have less overhead and will charge 20% less.  This seems to have been the case here.  Make sure the contractor is familiar with spa connections, as two of the spa dealers that I've spoken to told me that the have several spas a year burn out when the electrician is not 'spa friendly'.  Also, with the price of copper, make sure that they are not skimping on the wire gauge to save money (caught one bid with that as an issue...he quoted a smaller wire than I had requested).

HTH...from a newbie who is in the middle of researching and (hopefully) buying a new spa...

The Doob

D.P. Roberts

  • Full Member
  • ***
  • Posts: 453
Re: Electrical Setup Costs
« Reply #12 on: October 24, 2007, 08:04:28 pm »
Quote
We did it ourselves.  The GFCI was $90.  We paid a little over $3.00 a ft. for the wire.  Then there was the cost for conduit and fittings, but this wasn't much so I don't remember.  Around here, the general rule of thumb is that electricians will charge the same amount for the labor that the materials cost...so $250 materials, $250 for labor....$500 total.  I have seen people on here with quotes all over the place for the same job.  

Did you have to get a permit for this, or get an electrician to sign off on your work? I'm thinking of redoing my wiring (eventually), and I know I can run 6/3 wire right where the 8/3 was, so I really don't want to pay an electrician for that part.
"It ain't what you don't know that gets you into trouble. It's what you know for sure that just ain't so." - Mark Twain

rphman

  • Junior Member
  • *
  • Posts: 67
  • Caldera Moorea 07
Re: Electrical Setup Costs
« Reply #13 on: October 24, 2007, 09:14:16 pm »
Did my own. Panel came with the Caldera tub, 30 feet from panel to panel in unfinished basement and 12 feet from panel to tub under deck. Cost me $200 plus a couple of hours.

RK23

  • Junior Member
  • *
  • Posts: 64
Re: Electrical Setup Costs
« Reply #14 on: October 24, 2007, 09:48:24 pm »
Quote

[size=16]Go Rockies[/size]  Sorry, RK.

My sox are doing allright so far....but it's early.

Hot Tub Forum

Re: Electrical Setup Costs
« Reply #14 on: October 24, 2007, 09:48:24 pm »

 

Home    Buying Guide    Featured Products    Forums    Reviews    About    Contact   
Copyright ©1998-2024, Whats The Best, Inc. All rights reserved. Site by Take 42